1.     Remove plastic trim bezel around handle by prying bottom edge out with fingers.

2.     Remove 3 screws on inside of tailgate using a Torx T-40.

3.     Release lock rods at handle assembly by unlatching plastic retainers.

4.     Extract the handle from the tailgate.

5.     Remove the metal rod that is in the handle itself. Replace the white plastic clip with the modified clip. Add the bracket to the clip and reinstall the rod. *see attached diagram #1

6.     Insert the short harness with the 2 bullet plugs into the drain hole at bottom of the tailgate. The end with the waterproof connector should run behind the bumper and under the truck. Push the harness with the 2 bullet plugs into the tailgate until it can be pulled through to the handle opening.

7.     Insert DynoLock into tailgate towards the passenger side.

8.     Place the factory handle on top of the DynoLock bracket and align the holes in the DynoLock bracket with the three holes in the tailgate and re-install the 3 screws

9.    Make sure the DynoLock locking pin moves back and forth freely. Connect wires from harness to DynoLock

10.   Reconnect the threaded lock rods by snapping into place.

11.   Connect the long harness installed in the tailgate by pressing the 2 pin waterproof connector together.

12.   Run the harness under the vehicle as close to the driver’s side trim plate as possible. Use the tie wraps to secure the harness to the frame. Be sure to avoid moving or hot parts under the vehicle, i.e. shocks, springs or muffler pipes.

13.   Drill a 7/16" hole in the floor under the driver’s side trim plate and insert the enclosed grommet.

14.   Remove left side kick panel and locate the gray ( Lock ) and Tan ( Unlock ) wires.

15.   Attach the 2 blue wire taps to each wire. Wrap the blue wire tap around each wire and squeeze close with pliers. Push the 2 pink male spades connectors attached to each end of the harness into the blue taps.

16.   Lock the doors with the driver’s side door lock switch. If the tailgate locks and the doors unlock at the same time, reverse the wires. Replace the kick panel and trim plate and the installation is complete.